Knox Video Technologies
16x16 Composite Video with Unbalanced Stereo Audio VT
MediaFlex 16
|
|
|
Description: The Knox Video Technologies’ MediaFlex series presentation
switchers accept up to eight or sixteen composite, Y/C, component or
analog HDTV video sources, eight or sixteen balanced or unbalanced stereo
audio sources, and connects any one of the input sources to one or more
of the eight or sixteen outputs with volume and tone control. An independent
8x8 VGA matrix (DB15HD) is available in the same chassis to route high-resolution
sources such as graphics generators or laptop pc’s to several downstream
devices such as data monitors and LCD projectors without loss of resolution.
Video: These presentation routers provide full-matrix switching of
multiple levels of video. Fully buffered, ultra-high bandwidth crosspoint
modules allow a variety of signals including composite video, S-video,
component and VGA to be switched simultaneously without crosstalk.
Audio: Audio controls include volume, bass, treble, balance, input
trim and mute. Adjust each output individually for optimal audio quality
in any environment. Salvo commands allow adjusting all zones at once.
Control: Front panel control with dual LCD displays, hand-held IR remote,
IP, RS-232 and contact closures. Fully compatible with Creston, AMX
and Vity third party touch screen controllers.
Dimensions: 4U Rackmount Chassis 19”x 7”x10” (WxHxD)
Warranty: 5-year parts and labor.
|
|
|
|
|
SPECIFICATIONS
|
 |
|
Video Channels:
Levels: 1 v NTSC or Y/C (S-VHS or Hi-8) or analog
HDTV (YUV or RGB)
1080i / 720p Compatible
Frequency Response: DC to 30MHz @ 1v <3db down
at 30MHz
Input Impedance: 75 ohms
Output Impedance: 75 ohms
Crosstalk: less than –70db@5MHz
RGBHV / VGA Channels:
Frequency Response: DC to 200MHz:
@ 1V <-6db
Signal, RGB: 1v analog
Input Impedance: 75 ohms
Output Impedance: 75 ohms
Signal, H and V: 0-5 vdc, TTL compatible
Input Impedance: 510 ohms
Output Impedance: 75 ohms
|
Unbalanced Audio Channels:
Levels: 2v. Unbalanced audio
Frequency Response: 20Hz through 30KHz
Input Impedance: 15Kohm
Output Impedance: 100 ohm
Crosstalk: less than –85db@1KHz
Balanced Audio Channels:
Levels: 0,4, or 16dB clipping at 18dB
Hum and Noise: Less than -90dB
Frequency Response: 20Hz through 50KHz +/- 1/4dB
Input Impedance: Bridging or 600 Ohm Termination
Output Impedance: 100 ohm
Crosstalk: less than –90db@20KHz
Connectors: Removable, screw terminal
|
Connectors:
Video: BNC
Audio: RCA
VGA: DB15HD female
RS232: 1 DB9 female
Contact closures: 1 DB25 male
Power Consumption: nominal 12v, 1.5 A
from internal switching power supply
Input Voltage: 105 to 250 VAC, 50/60Hz,
automatic sensing
Dimensions: 19” wide by 7” high
by 10” deep / Shipping
Weight: 12 pounds
Specifications subject to change without notice
|
|
|
|
|
|
|
|
