Knox Video Technologies
RS Series Audio/Video Matrix Routing Switchers
***Hi-Def Component Video with Balanced Stereo Audio (dual chassis)***
RS16x16HB
|
|
|
- 16 Video Inputs to 16 Video Outputs
- Breakaway Stereo Audio
- Battery Backup
- Flat to Over 100 MHZ
- Store/Recall up to 16 Patterns
- Manual and RS232 Control
- Vertical Interval Switching
- SAS (Simple ASCII Strings) RS-232 Instruction Set
- Composite, Y/C (4-pin din), and Component versions available
Applications
- Duplication
- Distance Learning
- Teleconference/Telemedicine
- Satellite Headend
- Prison Systems
- Surveillance
- Custom Home Entertainment
|
|
Knox’s series of high performance, 200 MHz, highband (HB) matrix
routing switchers are extremely versatile, easy-to-use and very affordable.
Housed in an ultra-thin rackmount chassis, they accept and route, on
the vertical interval, virtually any video signal. Our switchers even
route off-the-air and non-timebase corrected video. They also route
balanced or unbalanced stereo audio. Audio follows the video, or audio
can be routed independently.
Each of the switchers offers easy manual control via front panel operation.
Front panel LED’s indicate the current routed pattern at all times.
Non-volatile memory holds and restores the current pattern in case of
power interruption. Crosspoint patterns may be programmed, stored, and
later recalled. Our routing switchers can also be controlled remotely
by a computer, by a Knox Remote Controller and/or by a Knox Remote Keypad
Controller.
The RS16x16HB is a high performance audio/video routing switcher in
a thin profile 6-unit rackmount chassis. It accepts and routes almost
any 1 volt Composite, Y/C, or Component video input including off-the-air
and non-timebase corrected signals.
The RS16x16HB accepts and routes mono or stereo unbalanced audio up
to 2 volts p-p or balanced stereo audio from 0 to +18 dbm. Video and
audio inputs can be routed independently; they need not have the same
destinations.
Easy manual operation by front panel key pad, or send routing commands
from a terminal or computer to RS232 interface.
|
|
|
|
|
SPECIFICATIONS
|
 |
UNBALANCED AUDIO
Frequency Response
20Hz to 30KHz
Input Level
up to 2 volts p-p
Input Impedance
100K
Output Impedance
1K
Crosstalk
<-85db @ 1KHz
Connectors
(64) RCA
|
BALANCED AUDIO
Hum and Noise
<-90db
Frequency Response
20Hz to 50KHz +/- 1/4db
Level
0, 4, or 16dB, clipping at 18dB
Impedance
Bridging, or 600 ohms termination
Crosstalk
<-90db @ 20KHz
Connectors
Phoenix screwtype, removable
|
VIDEO
Frequency Response
DC to 200MHz, @ 300mv, <-3dB @ 150 MHz,
Typ -6dB @ 200MHz @ 1.0v, <-3dB
@ 115MHz
Input Impedance
75 ohms
Output Impedance
75 ohms
Crosstalk
all hostile: typ<-70dB @ 5MHz,
<-55db @ 20MHz, <-25dB @ 100MHz
one hostile: <-40dB @ 200MHz
Connectors
BNC
|
POWER
Consumption
nom. 15vdc, 500mA max.
Connector
5mm/2mm coaxial
DIMENSIONS
19” wide x 10.5” high x 2” deep
Shipping Weight
9 pounds
|
|
|
|
|
|
|
|
